My TR Galvatron has a stress mark on the left hinge of the flap that opens for the mask gimmick, is there a way to get rid of that without painting over it?

 

Try a blowdryer.

Carefully.

 

I've heard a lighter also works, is this true? Because I don't own a blow dryer lol.

 

Did you pull the chest panel down too far? Nevermore's advice is your best bet. Either use a hairdryer or steam from boiling water.


Or exchange it for another one.

 

I have no clue how it happened, I think the pin looks a little misshapen, like when I used to pull it down there would always be a soft bump that I thought nothing of. It still works fine, like this is purely cosmetic it seems. How does the boiling water thing work?Do I just hold it over the boiling pot? (I'd just return it but no stores around seem to have another Galvatron lol)

 

As much as I wanted to like that figure, I just couldn't get past the ugly head(master gimmick). I ended up returning it.

 

I've ordered the shapeways helmet and canon adaptor, it's a shame because it really looks good BUT ONLY FROM ONE ANGLE XD , and without the damn gimmick the head articulation is really good.