A few months ago my titans Trypticon fell over as his legs are always loose. Full tilt was on his chest and the gun on top. When it fell the gun broke and I didn't notice at the time. Now it's too late to glue it back as a piece snapped off and it's gone for good Can anyone make me a reproduction one cast from the original. You'd have to have the original. I'd be happy to buy a few as I guess the cost of the mould would cost a lot for one repo I'm sure there are lots of other collectors that need one too Thanks
I'm currently scanning one to print from my 3d printer. I should have one by Wed. Funny about the timing.
Are you going to upload your scan anywhere? I scanned my broken one over the weekend. Most of its fine but the back bit has been reconstructed Full-tilt gun from Titans Trypticon. - Transformersa by superrobotmayhem
First attempt at scanning and printing the gun. A littlw soft but it was a quick scan and print. What do you think?
Looks amazing. I printed the scan I made out at a few different angles and found 45 degrees pointing up was when I got the best results. Would you consider sharing your scan so I can compare it to mine? We might be able to combine them into one better scan
That was a once around. I'm going to try and do multi scans at differnt directions and maybe combine them. If you want get mw on facbook messager aprim primo is my name. I'm new to scanning just got the revopoint Mini. Not sure about it yet. These scan prints look great from a far but crappy upclose. Trying to tighten it up.
My scanner is an openscan mini made from a kit. With the piece being glossy black plastic the surface can be hard to scan.