Minor/Repaint: Studio Series Bonecrusher claws

Discussion in 'Radicons Customs' started by Hoptimus, Feb 11, 2019.

  1. Hoptimus

    Hoptimus How I roll.

    Joined:
    Apr 21, 2010
    Posts:
    2,025
    Trophy Points:
    202
    Likes:
    +244
    Added robot mode pics.

    Super easy Studio Series Bonecrusher mod- cut out the plastic between his smaller claws, so they can move separately.

    You can do the same with the larger claws, but this might cause one of them to fall off easily. I did it on one side, and the claw fell off, so I had to use a small screw to hold each pair of claws (1 large, 1 small) on. The large claw on his other hand held on, so I used a drop of super glue on the end of the pin to reinforce it. So this one may just be the luck of the draw- if the large claw on the end of the pin is tight, you may be OK, but if it's a little loose, it will likely fall off, and you'll have to use screws or a new pin or some other solution. YMMV.

    Bot mode:
    IMG_20190214_182355370.jpg

    IMG_20190214_182441872.jpg

    A bonus to cutting apart the large claws: they fold away more tightly in alt mode.
    IMG_20190211_122922392.jpg

    IMG_20190211_122909681.jpg

    IMG_20190211_122933380.jpg
     
    Last edited: Feb 14, 2019
    • Like Like x 15
  2. Hoptimus

    Hoptimus How I roll.

    Joined:
    Apr 21, 2010
    Posts:
    2,025
    Trophy Points:
    202
    Likes:
    +244
    Bump for robot mode pics.
     
  3. tonysandlin

    tonysandlin Well-Known Member

    Joined:
    Jul 12, 2011
    Posts:
    2,561
    Trophy Points:
    222
    Likes:
    +6,357
    Simple yet effective!
     
  4. kmopotato

    kmopotato spends too much on this shit

    Joined:
    Sep 16, 2012
    Posts:
    1,511
    Trophy Points:
    197
    Likes:
    +752
    Those look like gang signs