Customs: Siege Seeker disassembly question...

Discussion in 'Creative General Discussion' started by jingles1, Nov 23, 2019.

  1. jingles1

    jingles1 Well-Known Member

    Joined:
    Jun 25, 2016
    Posts:
    319
    Trophy Points:
    142
    Likes:
    +363
    Hello. I was wondering if anyone has disassembled the Siege Seeker upper pile-ons. I want to remove the gray area circled in the pic but I can't figure out how to do it. Does anyone have any insight?

    Thanks in advance!

    thundercracker.png
     
  2. DarkProwler

    DarkProwler Well-Known Member

    Joined:
    Jul 29, 2002
    Posts:
    365
    Trophy Points:
    232
    Location:
    Indiana
    Likes:
    +436
    They're glued in on two posts, neither one really accessible. If you have a flat head jewlers screwdriver and a good hobby knife, it's possible to loosen around the edges and pop them off with pressure in the right place. It could also tear up the plastic, too.
     
    • Like Like x 1
  3. jingles1

    jingles1 Well-Known Member

    Joined:
    Jun 25, 2016
    Posts:
    319
    Trophy Points:
    142
    Likes:
    +363
    Thanks for the insight. Bummer that it's glued, but glad I asked so I don't tear it up!

    Thanks again!
     
  4. DarkProwler

    DarkProwler Well-Known Member

    Joined:
    Jul 29, 2002
    Posts:
    365
    Trophy Points:
    232
    Location:
    Indiana
    Likes:
    +436
    Took a quick pic of my current project to show the posts that are glued. They do come off, just need to get a good screwdriver in there to break the pegs. They'll come out easily after that, and can be glued back into place. Just need to be careful with the pressure.

    Pylons.png
     
    • Like Like x 1