Hi Guys, new to the forum. I believe this is the correct place, for this question.

I recently acquired a new ROTF Prime (great piece of engineering). One of his exhaust stacks, the rubber part, is slightly bent. I'm pretty sure some hot water would do the trick, but I can't figure out how to get the piece off (or at least that 'shoulder' section), to get at it. Any tips?

Cheers!

 

It's not held in place by a rivet or screw.

So all you need to do pull it off has hard as you can.

 

Well, that's easy! I tried pulling, but was chicken ;-) Some of the parts are quite stubborn, even just in the transformation. Thanks!

Cheers!

 

Twist the exhaust stack back and forth while pulling it out as hard has you can.