Here is it, ya'll. My POTP Volcanicus swan-schlong. My magnum-orifice. The Pièce De Résistance. It looks great with a huge sword and a set of thighmasters...and it's quasi-practical as well. I hope you all enjoy it! This upgrade is actually an upgrade to my existing chest upgrade design in that it is larger, more menacing and has provisions to carry a couple of Titan or Prime Masters. It still serves the role of filling in the empty spots on the front of the chest as well as providing additional support for the arms. AND, there is also a version intended to be specifically compatible with figures that have been upgraded with the Perfect Effects kit (the PE-compatible version will NOT provide arm support to Volcanicus in his stock (non-PE) configuration). ANNNNND there are two flavors of each of those versions (one with Stegosaurus plates on the front and one with gnarly-looking teeth on the front). That's a total of four different configurations (non-PE w/Stego plates, non-PE w/Teeth, PE w/Stego plates and PE w/Teeth). I have some of these available on my Shapeways store right now and I will have the rest up soon. Stay tuned for updates! Frank Schuler - 3D Printables by fjschuler - Shapeways Shops The pic immediately below is of the PE-compatible version...with Stego plates. PE-compatible with Stego plates: PE-compatible with Teeth: And here's a preliminary pic showing how the Titan/Prime Master covers open to reveal the Master hidden inside (the covers are attached using a pin made from a piece of paper clip wire).