Took some time and created three long overdue heads for CW Wheeljack mold: Exhaust/Marlboor: to go with the reprolabels sticker sheet: Tracks: because he is my favorite good looking guy to stand beside sunstreaker And Road Rage: the sensual veiled dancer!
yet more reasons i wish i could afford your kits. they look amazing! edit: as in my financial status......
Nice! I especially like that most of your heads come in two pieces so the eyes are easier to paint. Regarding that, I have a technical Shapeways question for you. How much smaller are the eyes than the sockets on the models? I was thinking of doing this with my models in the future. The little Frosted Ultra Detail material description on Shapeways(https://www.shapeways.com/materials/frosted-detail-plastic) says .05 mm for parts fit but that is significantly less than the accuracy (± 0.1 - 0.2 mm ).
I make the eyes 0.05mm smaller than the pass-through on all sides. Not only eyes but all tabs connectors etc. It has been working well for FUD/FED, but not so well for WSF of course.