Discussion in 'Radicons Customs' started by valguerra, Apr 21, 2020.
I printed out fortress maximus gun for my son. Not bad. Ran out of blue so quick switch to green.
That is perfect g2 colors!
I was running out of blue. So did a switch to green.
It looks really cool, but it looks like two different guns smashed together. the barrel needs to be a little smaller or they handle bit needs to be a little bit bigger
Had to modified it. Got filled with filament were to insert the barrels together. Thatd was printed at the 100% not scale. Will do another one but going to lower the support density. This will be easier to remove.
That's a pretty awesome mid-print colour shift Valguerra. The design itself shouldn't need supports at all, so that should stop the disruption to the connector pieces. If you're having adhesion issues a raft should be all you need.
Cura automatic did the support. But going to print it again.
My second version print. No support. Out of blue and green.
That seems much better. I'm assuming it went together easily? Those colours are brilliant too, they scream G1 Headstrong!
Had to sand a little the little insert. But it went smooth. I think need to adjust the cavity about .5mm bigger and it slide right in.
Separate names with a comma.