here’s one of a few fully printed figures I’ve made. Once I figured out that filament can be used as pins I’ve been wanting to make some figures at this scale. I became particularly board at school last week so decided to design it in my free periods. Enjoy the pictures! Dwarfed by micro masters and about a head taller than titan master he’s great fun posing with smaller figures... ...and even voyagers. Out he goes for his commute to work though he’s completely out of scale with everything (say for city bots and unicorn I suppose). But this doesn’t stop the Titan master from making an effort I even made him a trailer though getting it to open up like the original was a challenge so I did the next best thing Though if this Powermaster armour isn’t big enough, there’s always an Optimus with a big enough cavity in his chest Thanks for reading, I have a Megatron in the works so be looking forward to seeing that soon. If you’d like to purchase the figure or the stls then feel free to pm (though I warn you I’m not used to selling anything across turbo internet)
that's a really cute little design man, I love that you effectively made a tiny ginrai with the trailer
I thought it would be better than to struggle engineering a trailer that opens up like the original at that size, its basically just a glorified sock if i knew how to paint him i would, perhaps once I've done my megaton I'll have a go at em both I was thinking that as i began posing the lil guy with titan masters Thanks to all u guys and everyone whos liked! Means a lot
He may look small but with the amount of times I had to reprint pieces because the fit was off has created an Optimus graveyard Thanks! Good point, I didn’t even think of that