Pretty simple, I just carefully cut off the parts that had his upper jaw on them and then glued them to his back. And by carefully I mean sliced my finger open with a brand new exacto blade. But I think it looks pretty good. I'd like to get a few more sharkticons, but I don't think I'll do this to all of them.

 

That's the way he should have been, good work! Be careful with those xacto blades  

 

Thanks.

Yeah, there was just no way around on the legs,i had to take the whole top jaw joint. And the only difference inside the mouth is two seams where I cut along. I didn't remove anything at all, it just fits back together.

 

Awesome. Nice job, huge improvement.

 

Well now...why was this not a design decision in the first place? If only those hands/feet could fold in and out for both modes...regardless this is most impressive.

 

I like it!   Well done. Beware those sharp objects, they bite like a sharkticon! 
Just a safety tip. 

 

does it still transform or is it a partsformer now?

 

Thanks a very one.  

And yep, it still transforms the same. You just fold his legs up over his back.

 

I love it, now he looks like he has a shark-mouth hoodie! I'll have to do this to however many of mine I end up getting.

SHRINKING HOLLOW FORMERS.

I'm just kidding, all I know is that thread is a mess, if you're involved, I meant no ill. pls dun hurt me

 

Nice work!