Discussion in 'Radicons Customs' started by anemis, Jun 15, 2009.
so here is the sequence of construction of animated omega supreme ..
What was the standing height?
13 1/2 inchs high
last part !!
I WILL be doing one, sir. Thanks for the step by step.
Badass! SOoo Bad Ass!
Is it Plastic or card or what?
man i normally dont comment on the radicons cus most of them are meh, or doable by myslef, but this, this pretty damn sweet
you should review this on youtube i would love to see it
Your Project Omega has been one helluva success. He IS Omega Supreme!
Damn you're good.
HAHA good luck. dont forget the audio/voice device!
it is so cool ,i like it
that thing is so sweet...what are those pins you use for the rotating bits?
if your refering to the earlier pics where you see a skeleton frame, that was just for proportions and mesurements... thoses were taken out when the measurements were correct...
no sorry, my fault, I meant what did you use for the joint's pins(?) Im guessing is what you'd call them...instead of screws like in the elbow joints they look like little inverted caps.
Separate names with a comma.