Can anyone tell me if there is a safe way to remove arms micron ports from tf prime tfs?
Thank you

 

I duno, fill them in with putty and sand them down I guess? Cuz AM ports are just 5mm ports right?
And what figure are you trying to remove the ports from?

 

No they stick outward some have slants on the side too...I just need to get the glue. Loosened...and I said in the question what I'm trying to take them off from..transformers prime tfs...the arms micron ones

 

Yes but WHICH Arms Micron figures??

 

Oooo lol sorry knockout ^_^

 

Oof, yeah. I can see why you wanna remove those ports. Are those separate pieces or actually moulded into the figure? If they're separate you could try to heat up the plastic a little bit and wedge a thin flat blade or similar thing beneath them and wedge them off if you can break the adhesive.

 

I can see clear glue. I put him in a bag threw him into the freezer for another 4 hrs and then I'm gonna try to pry it off after that

 

OK, if the adhesive shrinks from the freezing that would make things a lot easier.

 

i'm more than fairly certain this should probably go to creative general discussion

 

So i ended up getting most of the stuff removed, but theres the left over glue though on the hood and door, whats teh best way to desolve the glue and not plastic?

 

Ok cool thank you. Was worried it would eat the plastic tho. Thnk u!