That is good to know. Thanks!

 

The additional bigger blue pieces are for truck mode were the trailer would be attached. I'm not sure of thier exact purpose given a trailer to fit this isn't going to happen. They essentially clip the legs together where the tow hitch point would be, though they seem redundant as the legs already tab together securely.

Mine came with one of the bigger blue pieces fitted alread which I had to remove to transform, with the second one in the bag with the other bits and pieces.

Hope this helps

 

Same issue with the head one. I'm thickening up The walls with some gorilla glue

 

I love him. Perfect for my 6 inch figures

 

He's on the move! In transit to final destination!! Magically he went from New York customs to a New Jersey sort center without anyone knowing. We shall see what comes next.

 

the Head cover is a waste of time. it doesn't stay in at all. it just falls right off.

 

Also, not a single person has yet to answer me.

How does this fit together so it no longer just falls out of the metal matrix housing?

hell, How does the crystal itself stay together without the electronic part falling out?

NONE of it pegs or tabs together.

 

I’m waiting for people to have Lewin Prime review other figures in his hands, such as getting really introspective about, say, his Cyberverse selves.

Or even... a stop motion film of Lewin Prime transforming other figures. Now, that could take a while.

Probably glue, poster putty, or double sided or rolled over tape.

 

Mines in Jersey now too yay!

 

I think I figured out how it's supposed to be stored in the chest now. You have to make sure the larger matrix hole is facing towards the back, while the smaller hole is facing the front. It's the only solution that makes any sense. That has to be what Lewin Resources intended.

 

Mine stays in the matrix with friction. It only falls out if I push too hard from the back(it clicks to turn on and off). It doesn’t look like the plastic itself locks together or closes in any way over the electronic bit. Just have to hold the plastic piece in front(bigger hole) while pushing on the piece in back to turn it on or off. I store my matrix like intended and the crystal doesn’t fall out.

 

(check out the post above yours)  

 

Mine showed up today! Had a different tracking number than they gave me. Glad to say there are no issues with my copy. This thing is awesomely huge! Transformation at this size is damn fun, but gotta say, my arms got quite a workout.  

Now, just waiting for my batteries to arrive.

 

Saw that post. I haven’t had a chance to put in batteries. Doesn’t seem logical to put in that way because the led is on the side with the bigger hole. Not sure how it would look lit up if it’s facing in. Only benefit would be easier to turn on/off, because it’s a PITA to take the whole thing out, turn on, then insert in chest. Can’t confirm any difference in lighting until I get some batteries, just assuming.

 

Mine still says processed through New York September 11th. I contacted the post office through email and they called me today saying that it hasn't been processed yet. The left hand doesn't know which dick the right hand is playing with 

 

Processed in new york usually just means it's arrived and going through customs. Don't get excited till it leaves the state.

 

Was starting to think they just took time off and blamed the hurricane down south. Not like government employees don't get countless days off or anything

 

He could crush Starscream with one fist!

 

Can we open her chest and see if she has the matrix of leadership?