Tamiya Basic Putty, sanded down with 100 grit and then fine grit
thank you , it was quite simple and basic... it is mainly made of clay and resin,just thrown on a board into a base shape then added hills and rock type bits to it
then scattered pieces of transformers all over it, the led in the deadbots eyes are just simple leds attached to a 9v battery
the deadbot post is bammbo sticks attached to each other to form a cross and the barbed wire was using this guide(but i used thicker wire)...
Nurgle's Rope - How to make realistic barbed wire --+--+--+--
used grout to add dirt and grit to the tf pieces, then repainted everything
spray a matt varnish on the base to act as a glue, then spinkled sand on top, the sprayed again with the matt varnish
hope that helps
Separate names with a comma.