Stylin Online T-Shirts
 
Register Rules Be A Supporter Members List Social Groups Mark Forums Read
Hobby Link Japan TFSource Big Bad Toy Store Robot Kingdom ToyArena Captured Prey

06. Creating Styrene Hinges

Closed Thread Thread Tools
Old 03-13-2011, 10:25 PM   #1
Semi-retired customizer
Wikkid's Avatar
Join Date: Oct 2004
Posts: 1,490
Location: Saskatchewan, Canada
Collection Count: 120
06. Creating Styrene Hinges

Styrene Hinges:

This project is to create a way to flip the hand back into the forearm. It requires two pieces of different sized styrene rod (rods that tightly fit within each other). It also needs a panel with cutout for flippy action:




Slice both rods to the same size (whatever size fits within your project). Cut the larger rod into three pieces. As you can see from the image, the central panel is larger than the two edges. Try to match those sizes with your styrene rod cuts (the smaller inner one stays in one piece). Use a very small amount of glue on each of the outer edges - too much glue and you run the risk of having it flow into the center section and bung up the whole mechanism:




Glue the hinge into place. The sides need to be glued to the outer edge and once inside the boxed forearm; they will be glued to the sides of that as well. The central piece should have no glue on it, allowing it to rotate freely:




. . . . and the final product:




NOTE: The setup shown here in this image has paneling on both sides allowing for a flush appearance when flipped:

Attached Thumbnails
06. Creating Styrene Hinges-basic24.jpg   06. Creating Styrene Hinges-basic25.jpg   06. Creating Styrene Hinges-basic26.jpg   06. Creating Styrene Hinges-basic27.jpg   06. Creating Styrene Hinges-basic28.jpg  


Last edited by Superquad7; 04-08-2011 at 05:12 AM..
Wikkid is offline  
Closed Thread


Thread Tools

Posting Rules

Tempting Collectibles for Transformers and Godzilla