By Generation: Articulating G1 Soundwave's Legs

Discussion in 'Tutorials and How Tos' started by Razorclaw, Jan 25, 2009.

Thread Status:
Not open for further replies.
  1. Razorclaw

    Razorclaw Are ya gonna draw pistols

    Joined:
    Jun 7, 2003
    Posts:
    5,174
    Trophy Points:
    317
    Likes:
    +106
    . . . . The mod (legs) and the scratch work (guns) were really minor, but the end result is great . . . .

    [​IMG]

    Now that I think about, while the work is minor, explaining it isn't that simple.

    Steps needed:

    1. Try bending Soundwave's legs back. You will see gray parts of his lower legs (at knee level) getting in the way. These need to be cut off, so do that first (disassembly required).

    2. Cut 1 mm off the ridges' tip that are on both sides of both of his thighs.

    [​IMG]


    3. Sand down corners at the top and back of Soundwave's lower legs on both the outer and inner side (after you cut of the gray plastic parts, assemble the legs, you will see what is getting in the way of what when you try bending the legs again).

    [​IMG]

    This step will take a lot of trials to get it right, as you will need to sand down those corners incrementally, a little bit at the time, so you will need to assemble his legs to see if you got it right after some sanding.


    Tools needed:
    - X-ACTO knife
    - rough sand paper (P220, aluminum oxide)
    - small grain sand paper for wet sanding (the one I got has P2000 and silicon carbide on it)

    First sand down with the rough sand paper, and then finish with the smoother one, it will give it a nice, rather smooth surface.
     

    Attached Files:

    Last edited by a moderator: Jun 26, 2010
    • Like Like x 2
Thread Status:
Not open for further replies.