I do not know if any one has mentioned it but if you have Lockdown and Ratchet, lockdowns Engine block/Ratchet's EMP generator, it losk into the spot on ratchets wrist, very neat cross figure feature.

 

This has been noted a few times before.

Is rather neat though, yes.

 

nice! didn't know that, got a picture?

 

Check the feedback forums for pics. Most of these little features are well covered in there. There is also a way to connect it to prowl

 

This has been known, I learned this in Peaugh's review.

Anyhoo, it's a really nice feature. When my bots are in robot, I alway's give it to Ratchet.

 

Old news, but they're still damn cool !

My Ratchet and Lockdown is on there way from the US, and i cant wait to try this out !
... i just dont hope that the generator will be 2 lose to fit in ...
Well, nothing a lil of clear nail polish cant fix?  

 

tight

Actually every thing is nice and tight, when you are transforming them be careful the plastic they are using for these is different then usual and the joints and pegs seem to all be very sturdy.

 

i had to shave the peg down on my ratchet to make it fit.

 

same

 

It's not really attached, I just sorta set it on the lightbar when I made that up.   One could modify the hole on the EMP to make it snug.

I don't have this problem.

 

Actually, someone found a way to snap the lightbar on Prowl into the groove on the side of the EMP.

 

Well it can also gon on Prowl,Split lip should use that.