Botcon 2016 Ratchet In the run up to Botcon 2016 a rumoured list of exclusives did the rounds. As it turned out the list was very accurate with just two mistakes: The first was Airazor from Slipstream wasn't on it, replaced with Arcee from Legends Blackarachnia, which I thought made sense as there was a previous Botcon Arcee from Transmetal 2 Blackarachnia. The other thing wrong on the rumours list was the identity of the Customise Class toy. The item the list had on it was Blue Bluestreak from Dead End/Streetwise. This made vague sense: there's already a Streetwise use in the Botcon exclusives and the customise class toy tends to be a reuse of one already in the exclusive packages. Blue Bluestreak is a "variation", although it only exists as a Diaclone toy with a lot of collector interest and by doing Blue Bluestreak here it allows a proper silver/anime Bluestreak to be done in the main Combiner Wars line or as part of another Autobot Diaclone Combiner boxset. I wait to see any version of Bluestreak in any of his three colour schemes, but in particular the rumoured blue one, from the various customisers at work out there. What we got instead was something of a surprise! Ratchet from First Aid is a pretty logical choice if you're trying to all 18 Diaclone Autobot cars in Combiner Wars but I'd have thought that it was considered worthy of a more main line release as part of another Autobot Combiner than a convention exclusive. Potentially this is a worse case of underestimating the potential of/demand for a toy character by putting it in the custom class than the amazing "How many toys can we homage?" Longarm/Shockwave and the "you could have sold this at retail and I'd have bought it" Universe 2 Generation 2 Sideswipe. However there's an earlier Botcon Ratchet made from Energon Tow Line so perhaps we should have suspected this one more strongly as it fits the 2016 Botcon/TFSS 5.0 theme of looking back to past club releases. In earlier versions of this review, when considering Future Repaints, I said: If you stripped the paint off either the Combiner Wars or Unite versions of First Aid then the resulting vehicles would look essentially the same. The differences in plastic used are only seen in robot mode. Yes there's a new head, in white, which was hinted at in First Aid's pack in comic. The combiner connector, upper arms, upper legs and knees are now grey with the shoulders, elbows, waist and knee/leg struts becoming black. The chest, like all these other parts, previously red, is now cast in white. The existing First Aid head is also included in this kit and it's grey, showing it to be on the same sprue as the grey parts above, but I'll be surprised if many people used it! The use of the grey and the black on the parts colour choices may seem odd but it means that Ratchet is once again a White for Red Ironhide in robot mode. The Customise Class was given five sticker and paint options for their Ratchet: Marvel G1, cartoon G1, G2, Shattered Glass Ratchet and a fifth deco option using the First Aid head as Medix. The attendees at the class were allowed a sheet of G1 Ratchet stickers and one of the other choices. My Ratchet comes from the assembled versions sold at the show so is lacking these stickers but to be honest I'm not sure I'd apply them anyway and my hand is a bit to wobbly for painting. I think they've done the perfect deco for Combiner Wars Ratchet's vehicle mode ALREADY and that was what was used on the Japanese Unite Warriors First Aid reducing the red to a stripe on each side & the lightbar and painting the windows blue. There's been too many Ratchets with far to complicated decos Universe Ratchet, I'm looking at you! The Original Ratchet is definitely the pattern to follow with minimal paint and sticker applications. That only leaves the rather vexing matter of the head, but given that I can't paint to save my life the one I have will be staying white all over whatever I think! The package is complete with the axe and Hand Foot Gun in clear blue, possibly a reference to the clear blue parts packed with Botcon 2005 Ratchet and Ironhide or the hands/feet used on the Energon Combiners. I like that a Combiner Wars Ratchet exists. I'd like it better if it existed as a finished version with painted windows, a single red stripe down the side and a red Marvel head but it doesn't. Since one of the remaining ten Diaclone Autobots has fallen the remaining nine don't divide up equally into two groups of 5 with Inferno/Grapple as body. So it looks like my dream of owning all 18 Diaclone Autobots in Combiner Wars form has taken a severe dent. Ratchet and Ironhide's heads both popped off during transformation so I took the opportunity to do a little parts swapping, using the Unite First aid as a base as that's the closest to Ratchet in vehicle mode, to see which head looked the best on him in robot mode: Unite & CW Unite wearing Ironhide's head: Unite wearing Ratchet's head:
Were you guys able to looks through the instructions booklet that were distributed for this guy? If so, did it give info about how to paint the figures and all that?
