WST Flamethrower hip Stickers.

Discussion in 'Transformers General Discussion' started by jestermon, Jun 6, 2007.

  1. jestermon

    jestermon Well-Known Member

    Joined:
    May 10, 2006
    Posts:
    7,597
    Trophy Points:
    232
    Likes:
    +7
    Removing WST Flamethrower’s Clear Hip Pieces

    When removing Flamethrower’s hip pieces to apply the factory stickers in the Reprolabels set, it is almost impossible to pry them out like on Desert Warrior.

    The best and easiest way is to push up the 3 prongs on the inside of the leg so you can avoid digging into the leg with a small tool to pop it out, like I did.

    You can see the 3 holes on the outside and thus you can see where you need to push up from the inside.

    After you do this you must apply the label to the screw section so that when you replace the cap it will not move around.
     

Share This Page