Customs: Use glue to tighten RID Megatron's Wings?

Discussion in 'Creative General Discussion' started by Nefud, Jul 9, 2011.

  1. Nefud

    Nefud Well-Known Member

    Joined:
    Feb 2, 2006
    Posts:
    1,718
    Trophy Points:
    161
    Likes:
    +0
    Well, technically this thread is about a Botcon Deathsaurus I bought, but I wanted more people to read this. :)  It's the same mold, so hey!

    I bought a Deathsaurus, and was sad to find that the wings are loose. I'm considering dropping a little superglue in there and working it around, but if anyone has any better ideas, or advice on how to do it properly, it would be VERY appreciated. Thank you!
     
  2. GENOZAUR

    GENOZAUR Banned

    Joined:
    Mar 17, 2007
    Posts:
    3,209
    Trophy Points:
    151
    Likes:
    +0
    you might want to remove the pins first then use some slow setting super glue into the pin hole parts on the wings so that when you go to reinsert the steel pins back into the wings to secure the mback together you will have plenty of time to flex the wing parts so that the glue will not cause them to permenently set in a single static non posable possition
     
  3. Nefud

    Nefud Well-Known Member

    Joined:
    Feb 2, 2006
    Posts:
    1,718
    Trophy Points:
    161
    Likes:
    +0
    I've removed normal pins before, but this one is flat at one end, and I can't even see the other end...Is there a tutorial for that kind?
     
  4. Nefud

    Nefud Well-Known Member

    Joined:
    Feb 2, 2006
    Posts:
    1,718
    Trophy Points:
    161
    Likes:
    +0
    Bump?
     

Share This Page