First of all, just wanna say that process's shapeways G1-esque Fusion Cannon rocks! Anyway.. Without further ado, here's the current progress.. I carved off the plastic bits and detached the entire back kibble. But I wasn't careful enough, and thus resulted in minor melting accident on rear side of Meg's left thigh, as evidenced on picture above. Thank goodness the heatcutter didn't even melt the black joint part within it, or it's all over for me, and this one ends up a failed custom. And I reminded of IDW's AHM Megatron, especially his back kibble, and thinking of putting his trigger back on his..... back. Yeah. :| Therefore I cut & detach the wings, and also the pin, from the trigger kibble. Here's the result. Not too smooth, and leave quite a mark there during my attempt to cut off the pin-holding plastic bits.. Anyhow, just waiting for my paints to arrive, so I can start painting his fusion cannon. Regards, Caine.