Customs: tightening pins?

Discussion in 'Creative General Discussion' started by Orion_Prime48, Jun 15, 2009.

  1. Orion_Prime48

    Orion_Prime48 Super Sentai Purist

    Joined:
    Dec 18, 2007
    Posts:
    8,355
    News Credits:
    3
    Trophy Points:
    176
    Likes:
    +3
    not sure if this is the right section but im sure a Radicon can help me out

    I got a Armada Leader 1 minicon earlier and its really loose. how can I tighten up his joints? all of them are pins so I have no clue how to do it.
     
  2. mr_soundwave

    mr_soundwave operation: tidalwave

    Joined:
    Mar 19, 2008
    Posts:
    451
    Trophy Points:
    76
    Likes:
    +0
    aurascope offered this in the thread where i ask the sameish question, it sounds solid too :) 

    tamiya's thin cement will help.
    it is very fluid and flows like water.
    it will fill and seal the gap.
    it's a must for every kitbasher to have.
     

Share This Page