By Generation: The $4 Allspark Cube

Discussion in 'Tutorials and How Tos' started by CJS, Jul 30, 2014.

Thread Status:
Not open for further replies.
  1. CJS

    CJS Active Member

    Joined:
    Jul 29, 2014
    Posts:
    40
    Trophy Points:
    26
    Likes:
    +0
    Was asked a bit about this so here's a quick pic thread of how I built a light up Allspark from a Michael's picture cube.

    The start:

    [​IMG]


    I then printed grabbed a fold out picture of the Allspark surfaces and did some photoshopping to make it traceable:

    [​IMG]


    Then, I put it inside the cube using a 'lil adhesion spray to hold it on the inside and then sealed the cube using model glue and started carving and grinding out the pattern.

    [​IMG]


    Carving [took] about 14 hours, if I recall. The more you do [is] the better the result - just be mindful of your depth. When you feel good about it, use some Scoth Brite and smooth all the carvings so it has a solid ore kind of texture:

    [​IMG]


    Then paint, here’s a bunch of sides completed.

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]


    Here’s the template.

    [​IMG]

    Enjoy!
     

    Attached Files:

    Last edited by a moderator: Aug 6, 2014
Thread Status:
Not open for further replies.

Share This Page