By Generation: Scoria - Loose Jaw Fix

Discussion in 'Tutorials and How Tos' started by Grimlock4523, Jun 26, 2014.

Thread Status:
Not open for further replies.
  1. Grimlock4523

    Grimlock4523 Me Grimlock, KING!!!

    Joined:
    Aug 14, 2013
    Posts:
    2,138
    Trophy Points:
    202
    Likes:
    +231
    LOOSE JAW FIX

    ***Of course proceed at your own risk***

    I used this product to tighten up the jaw on Scoria. This is a real easy fix. Now my Scoria's jaw is tight.


    1. Get this stuff:

    I bought it at Walmart. Just be warned, this stuff is sticky so I recommend using gloves. Try to avoid getting this stuff on your fingers or else you may transfer it onto your Scoria. You will also need a toothpick and Q-tip:

    [​IMG]


    2. OFF WITH HIS HEAD!

    [​IMG]

    [​IMG]



    3. Remove the jaw:

    This is actually real easy. Just apply pressure as shown:

    [​IMG]


    4. Apply the sealer:

    Apply sealer to the diecast portion of the jaw, not the pegs on the head. Chome and sealer do not mix. It stains and is hard to get off. Just work with the jaw(see pictures below):

    [​IMG]

    [​IMG]


    5. Allow adequate time to dry:

    I waited about half hour initially and it was still wet, so I just reapplied and let it sit overnight.


    6. Replace jaw:[/COLOR]

    Carefully place back the jaw. Check jaw looseness. If still loose, reapply another coat as above:

    [​IMG]


    Thanks for the advice. I will definitely wait.
     

    Attached Files:

    Last edited by a moderator: Aug 29, 2014
Thread Status:
Not open for further replies.

Share This Page