Customs: ROTF: DEVASTATOR how 2 add a ball joint head

Discussion in 'Creative General Discussion' started by encline, Oct 29, 2009.

  1. encline

    encline customizer of love TFW2005 Supporter

    Joined:
    Oct 5, 2006
    Posts:
    5,620
    News Credits:
    11
    Trophy Points:
    261
    Likes:
    +11
    What you will need:
    One Supreme class ROTF Devastator
    one mudflp leg (or other comparable ball joint with some length)
    demel or something to cut though hard plastic
    dremel to drill with\drill bits
    tiny screw
    4 rare earth magnets
    plumbers putty (or other strong adhesive)

    First: Cut off devastator's head from mixmaster including the wiring. You will loose the lights to the eyes unless you reconnect them. :eek: 


    Second: Remove mudlfap's lower leg and foot. Remove the screw and separate it. You will need to remove the foot and trim to fit inside the back of Dev's head. You will need your dremel and a drill bit to drill a hole while holding the shin part up to the roof of mixmaster's barrel. Add some epoxy to the spot around the screw hole and then screw it in.

    [​IMG]

    3rd: Once you have trimmed down muflap's foot, apply the plumber's putty and push the foot into place. Be sure to remove the putty from inside the ball joint. Also, ALWAYS MEASURE before you glue and adhere.

    [​IMG]

    [​IMG]


    Magnets for the jaws. Dremel out two spots on the back of Dev's head for the two magnets. Then dremel out a spot on each mandible. Epoxy and bam!! Removable jaws for when you want to pose him saying AAAWWWWWWWWWW....
    [​IMG]
    [​IMG]
     
  2. OMEGAPRIME1983

    OMEGAPRIME1983 Well-Known Member

    Joined:
    Nov 3, 2005
    Posts:
    12,305
    News Credits:
    2
    Trophy Points:
    277
    Likes:
    +55
    Ebay:
    Dude, that's cool. IF I ever pick up a devs, I may do this.
     

Share This Page