Discussion in 'Radicons Customs' started by Thlaylie, Jul 30, 2009.
Claws now articulate downwards and slightly upwards:
(Psst! Use the
Damn! You keep making that arm better and better.
Thank You I like Leader Megatron.
Damn man! That's so much better!!! Would you please make a tutorial for the rest of us? Thanks!
This is looking good!
Thanks Guys, It is fun posting here. A lot of good conversion ideas here. I will work on the tutorial, I need more pics for that.
how do you put the side claws down w/out ruining the toy?! it's too hard!
If you look at the top of the claw, there is a hinge pattern there. I razor sawed the front and back edges up to the center hinge tooth. then cut that out with an exacto knife. If you follow the outside spacer grooves molded in the plastic on front and back, you will neatly bisect the support struts. Then use a pin vise to drill holes through the backs and all 4 support strut halves. Thread a large paperclip through the holes and cut to length. Super glue the front and back "reservoirs". Now use your exacto knife to trim/ round the inner edges until the fingers move freely.
I'll put up some pics to show the cuts tonight.
Oh and don't forget to make it in tutorial format
Thanks in advance man!
I'll do my best.
Here You Go:
can you teach me how to make the elbow joint please !! ><
You will need to buy yourself a Leader Brawl for the parts. I am trying to figure out how to make a tutorial for this without taking Megatron apart. (He only lends me his arm for upgrades and is none to keen about that.)
I will have to do a bit of drawing on the pics, but I think I can do it.
Separate names with a comma.