Customs: Repair: Small front section of Classics Seeker cockpit bent. Thoughts?

Discussion in 'Creative General Discussion' started by BenjaminXavier, Feb 5, 2011.

  1. BenjaminXavier

    BenjaminXavier Well-Known Member

    Joined:
    Nov 11, 2010
    Posts:
    5,790
    News Credits:
    23
    Trophy Points:
    207
    Likes:
    +65
    Title says it all, really. This is an Acid Storm that I bought when he was out, then I never opened him till I started buying some of the new Generations figures. Once I did I noticed the flaw right away. If this were Dirge or Thrust I would have just returned/swapped him out, but obviously that's not happening. So anywho, does anyone have thoughts on fixing this? Hair dryer perhaps? Should I try to get the pin out and bend the part while its off the toy?
     

    Attached Files:

  2. Satomiblood

    Satomiblood Prototype Black

    Joined:
    Nov 2, 2007
    Posts:
    19,337
    Trophy Points:
    247
    Likes:
    +4
    I've encountered that problem before, but was able to snap it into place after wiggling it around a few times.
     
  3. BenjaminXavier

    BenjaminXavier Well-Known Member

    Joined:
    Nov 11, 2010
    Posts:
    5,790
    News Credits:
    23
    Trophy Points:
    207
    Likes:
    +65
    It doesn't really want to snap back into place, the plastic is too hard. Here's a *BUMP* to see if anyone else is browsing a few days later with some ideas...
     

Share This Page