Yes I know, I have tried this before, but the pieces were too big to fit in my small pot. Until Now. This past weekend I came into possession of this little guy. He is hand sculpted obviously and not a bad gate. It does have a couple problems. First its too thick for my taste, around an inch in places. Second, it is cast in plaster of paris. WAY too fragile. So I hoped against hope that it would fit in my pot, and it does. With about 1/4 inch to spare. So I boxed him up. and rubber was poured. I took it out of the pot this morning. WOOHOO the box held. I was a little worried since it was made of posterboard. So I deboxed it and here is my new shiny stargate doughnut. it has an 8 inch OD. first attempt, forgot to put a board under the mold to make sure its level. thicker on one side than the other. 2nd attempt, funny how much a different keeping the pot level makes. much more consistent thickness on this one. Enough folks have told me they want one that I will be selling them on a by order basis. they are a lot of resin so they will be 25 plus shipping. PM me if you seriously want one.