Pin slowly coming out of a hinge?

Discussion in 'Transformers Toy Discussion' started by Bountyan, Jul 26, 2011.

  1. Bountyan

    Bountyan Well-Known Member

    Joined:
    Sep 19, 2008
    Posts:
    15,864
    News Credits:
    11
    Trophy Points:
    262
    Likes:
    +62
    I bought Warbot Defender yesterday and the hinge that holds the chest piece together with the head/backpack has a pin slowly coming out one side of it. Is there any fix so the pin stays in place? Right now the only solution I have is to keep him transformed in helicopter/robot mode so I don't have to move the black pieces that block it from moving.
     
  2. Gingerchris

    Gingerchris Telly-headed Tyrant

    Joined:
    Feb 17, 2005
    Posts:
    14,696
    News Credits:
    5
    Trophy Points:
    262
    Likes:
    +43
    If it's coming out then can't you just push it back in?
     
  3. Bountyan

    Bountyan Well-Known Member

    Joined:
    Sep 19, 2008
    Posts:
    15,864
    News Credits:
    11
    Trophy Points:
    262
    Likes:
    +62
    Well it came out quite a bit before and I was able to manage to push it back in, but I just want to make sure it stays together.
     
  4. Gingerchris

    Gingerchris Telly-headed Tyrant

    Joined:
    Feb 17, 2005
    Posts:
    14,696
    News Credits:
    5
    Trophy Points:
    262
    Likes:
    +43
    Depending on which part has to rotate to make the hinge work I suppose you coud put a tiny bit of glue around one end of the pin before you push it back in. However as I don't have this particular figure and have no knowledge of the bit you're talking about don't just go right ahead and try that without waiting for a few more suggestions from other perhaps more knowledgeable people first. :) 
     

Share This Page