PCC Bombshock assembly error question.

Discussion in 'Transformers Toy Discussion' started by Lothar Hex, Apr 22, 2011.

  1. Lothar Hex

    Lothar Hex Decepticon

    Joined:
    Jun 18, 2008
    Posts:
    374
    News Credits:
    1
    Trophy Points:
    92
    Likes:
    +27
    Recently purchased a PCC Bombshock and read on TFWIki (Bombshock (PCC) - Transformers Wiki) about the assembly errors on the legs. I managed to sort out the backwards combiner pegs and I thought I had swapped the lower legs the right way round to make the vehicle mode wheels more ever...however I wasn't sure if I did it right so I swapped em again...and again, and again. Now I have no idea if I have the legs on the right way or not. Is there a way to tell? When I transform him to vehicle mode now, the wheels are even, but it takes a bit of faff to get the side panels to lock in place. Any tips?
     
  2. Goldlock

    Goldlock and don't call me Shirley

    Joined:
    Apr 10, 2011
    Posts:
    2,132
    News Credits:
    11
    Trophy Points:
    167
    Likes:
    +14
    I didn't even know about this! :dunce 

    *runs to get screwdriver*

    EDIT: did it earlier & found that the waist should be screw-side forward (under the..flap) with the inside of the left leg reading 'Tomy/made in China' while in robot or combined mode, if done correctly. There isn't a faff with the panels now on mine with them this way & everything seems fine.

    Hope this is of some help!
     

Share This Page