Customs: Opening TFA Bumblebee's Head

Discussion in 'Creative General Discussion' started by GizmoTracer, Jun 24, 2009.

  1. GizmoTracer

    GizmoTracer Well-Known Member

    Joined:
    May 2, 2009
    Posts:
    105
    Trophy Points:
    56
    Likes:
    +0
    Hey folks, I'm hoping somebody can help me out with this. I'm working on a few customs using the Deluxe Animated Bumblebee as the base (the Elite Guard deco specifically, for the sake of argument). Unfortunately I've run into a bit of a roadblock trying to open up the head(s).

    The two screws come out easily enough, but after that I'm stuck. The head is clearly three pieces, with the light-piping sandwiched between the front and back of the head. I'm not sure if the pieces are just snug or if they're glued together (the mold does use some glue in places) but either way there just doesn't seem to be anywhere to get a grip on the individual pieces or to pry them apart.

    Are there any tricks I could be using to get the head opened up?
     

Share This Page