Scratch Builds: Modifying and Building Heads with Wikkid: Installing Vents on a Robot Helmet

Discussion in 'Tutorials and How Tos' started by Wikkid, May 20, 2013.

Thread Status:
Not open for further replies.
  1. Wikkid

    Wikkid Semi-retired customizer

    Joined:
    Oct 16, 2004
    Posts:
    1,668
    Trophy Points:
    182
    Likes:
    +8
    Vented helmet base:

    A nice detail is to add venting to parts of the helmet. Here at the base of the helmet we will add this by cutting out the parts of the original helmet:

    [​IMG]


    These are the vents that face forward:

    [​IMG]


    Build around the vents panel by panel until they are enclosed:

    [​IMG]


    They end up looking like this after sanding off any overhang:

    [​IMG]


    Test fit:

    [​IMG]
     

    Attached Files:

    Last edited by a moderator: Nov 13, 2013
Thread Status:
Not open for further replies.

Share This Page