loose leg on tfc exgraver

Discussion in 'Transformers 3rd Party Discussion' started by Titanoverlord, Apr 27, 2012.

  1. Titanoverlord

    Titanoverlord New Member

    Joined:
    Apr 27, 2012
    Posts:
    3
    Trophy Points:
    31
    Likes:
    +0
    for some reason my exgraver has an FLOPPY loose leg I have tried to thicken the ball but i have been unable to remove the joint from the socket any advice would be apreciated
     
  2. kibble

    kibble Seeker style, yo!

    Joined:
    Aug 3, 2009
    Posts:
    11,403
    Trophy Points:
    277
    Likes:
    +1,341
    Mine had a loose leg so I pulled it off (took a decent amount of force) and coated it with super glue. After I let it dry over night (as well as rotated it often early on so a drip didn't dry on the end) I popped the leg back on and it was good. I'll probably have to do the same with Neckbreaker, too.

    You might also be able to use that futures floor wax that people talk about and apply that without taking the leg off, but I have no experience with that so I couldn't tell you for certain.
     

Share This Page