Customs: Long Haul Destruction: HELP NEEDED!

Discussion in 'Creative General Discussion' started by Jolt Customs, May 1, 2011.

  1. Jolt Customs

    Jolt Customs Seacon

    Joined:
    Aug 11, 2010
    Posts:
    587
    Trophy Points:
    101
    Likes:
    +0
    Hey guys...sorry for the double post...but i really need help getting out two screws on a ROTF Longhaul/HFTD Payload.

    The screws are located behind the flap with the cab attacted to the back.
    It is impossible to get the screws out...and i have tried to get the pins, that hold the flap in place, out...but they wont budge.

    Does anyone have any suggestions?
     

    Attached Files:

  2. Bigbot3030

    Bigbot3030 Well-Known Member

    Joined:
    Apr 5, 2007
    Posts:
    2,222
    Trophy Points:
    151
    Likes:
    +0
    Push harder on the pins? :lol 

    If you can't cut off that flap off, thats your best bet. those things are assembled in a certain way, and sometimes you have very few options.

    Randy!
     
  3. Treadshot A1

    Treadshot A1 Or just 'A1' for short...

    Joined:
    Jan 27, 2009
    Posts:
    7,528
    Trophy Points:
    197
    Likes:
    +4
    My dad's disassembled 3 Payloads for me. He heated the pin with a soldering iron, and then hammered out the pin after the plastic melted and the hole was thus bigger.
     

Share This Page