By Generation: Leg Modification the Alternators/Binaltech Acura

Discussion in 'Tutorials and How Tos' started by Superquad7, Aug 16, 2006.

Thread Status:
Not open for further replies.
  1. Superquad7

    Superquad7 We're only human. Super Mod

    Joined:
    May 19, 2003
    Posts:
    47,595
    News Credits:
    11
    Trophy Points:
    342
    Likes:
    +22
    (Photo credit to alexkingdom; many thanks for your help! ~Superquad7)

    This is an extremely easy modification for your Alternators/Binaltech Prowl and/or Camshaft figure. The transformation is relatively unaltered, and the result is an alternate look for the robot mode of this figure.


    This is the Acura prior to the modification:

    [​IMG]


    There are four (4) black screws on the inside of the legs. Remove these black screws holding the leg panels in place:

    [​IMG]


    Once the screws are removed, detach the leg panel from the leg (note the screws are different sizes and each go in a particular hole). Remove each leg and swap the legs:

    [​IMG]


    Once the legs are swapped, reattach the leg panels and replace the screws in their proper spots:

    [​IMG]


    Here is the finished result:

    [​IMG]


    As you can see, the articulations is greatly improved:

    [​IMG]

    [​IMG]
     

    Attached Files:

    Last edited: Oct 29, 2013
Thread Status:
Not open for further replies.

Share This Page