This is my TFTM voyager prime, and again...jus mod for the led works. Hope u all like it.... The bumper is drilled using 2mm bits. Behind of it, i solder with tiny blue led for each hole. I think tis is the smallest led. I used the handphone led. THose old school "black and white screen" phone, u can take it apart from there if u hav any, or mayb if u can stil find it on the market, jus buy. But i think it is very rare, all my tiny led is finish used up, due to all of tat stuff is my old stock, long time nvr visit those handphone sparepart shop. Also added 4 led for the waist area, as wat i did for the leader prime. This is much more easier. Jus unscrew the blue scope, cut the plastic, and make 2 tiny hole on the prime's red body part from side, there for inserting the led leg to hold it in place, no glue needed. Tis is how i did it, jus simply draw it out to show u guys, due to my wiring stuff is nicely in place...i lazy to dismantle it and snap a pic....hope tis will help u guys a little bit more. The red rod i draw actually is the led rod, after we cut from the headlights we've done, dun throw the remaining rod. Line it up and solder it into line shape, glue it in place. Haha, then u can slowly lineup and solder ur SMD LED to der, but u have to do it quick and nice, those SMD led can't accept too much of heat. Good lucks !!!