Customs: Installing Wings on Transformers Energon Shockblast

Discussion in 'Creative General Discussion' started by OmarJT82, Dec 27, 2007.

  1. OmarJT82

    OmarJT82 Well-Known Member

    Joined:
    May 18, 2007
    Posts:
    4,268
    News Credits:
    2
    Trophy Points:
    167
    Likes:
    +23
    Dear members,

    I am planning to modify my Transformers Energon Shockblast action figure by installing wings on him in order to turn his satellite form into a jet form.

    What action figures (Transformers or other) have wings that would work?
    What tools do I need?
    Where on my Transformers Energon Shockblast action figure do I place the wings?

    Sincerely, OmarJT82
     
  2. Soundblaster1

    Soundblaster1 The Heisenberg of Toys

    Joined:
    Oct 4, 2004
    Posts:
    13,996
    News Credits:
    11
    Trophy Points:
    256
    Likes:
    +11
    1. You need to be a little more specific. The wings can come from ANYTHING... It's just a matter of what look you're looking for.
    2. Exacto knife, Sand paper, paint (?), dremel (optional, but helps), pliars (you never know?), super glue (epoxy is even better)... That kind of stuff. If you want to scratch build wings, you could use Styrene (found at most hobby stores)
    3. Really depends on the wings, but probably around the mid-section (on the satellite panels would probably be ideal, but I'm not sure how they play out in tank mode)

    Hope this helps
     

Share This Page