Minor/Repaint: In Need of Assistance: 3D Modeling

Discussion in 'Radicons Customs' started by Dicron, Aug 5, 2011.

  1. Dicron

    Dicron Well-Known Member

    Joined:
    Jun 27, 2011
    Posts:
    104
    Trophy Points:
    61
    Likes:
    +0
    I have a design for the Master Sword that I want to convert to 3D for submission to Shapeways, but I have a terrible time using their 3D modeling software, is there anyone out there who'd be willing to give this a shot for me?

    The sword is supposed to be 40cm in length, the handle being roughly half that. The blade itself should be 5mm at center and taper to an edge, except for the black triangle which is part of the guard.

    [​IMG]
     

    Attached Files:

  2. Treadshot A1

    Treadshot A1 Or just 'A1' for short...

    Joined:
    Jan 27, 2009
    Posts:
    7,528
    Trophy Points:
    197
    Likes:
    +4
    Wrong place bro. Head to the Creative Marketplace. There are designers out there willing to take commissions, including me, it's just all a matter of how much one can spend and such...

    Oh, and a 40 cm sword is going to cost a sh*tload to print. Even if the blade is only half that, you'd be looking at a $30-40 sword, maybe even $45 as a rough guess to have it printed in WSF.
     
  3. Bigbot3030

    Bigbot3030 Well-Known Member

    Joined:
    Apr 5, 2007
    Posts:
    2,222
    Trophy Points:
    151
    Likes:
    +0
    Is there a specific reason you want to print it? Why not just sratchbuild it?

    R!
     

Share This Page