HELP please??

Discussion in 'Transformers Toy Discussion' started by Cranckasional, Jul 9, 2011.

  1. Cranckasional

    Cranckasional Well-Known Member

    Joined:
    Jun 6, 2011
    Posts:
    405
    News Credits:
    2
    Trophy Points:
    76
    Likes:
    +2
    Were can I find a rod/tube something that has the with of a mech tech handle but is 3 to 4in Long??

    I found a way to give Prime an axe, I got the axe part but I need the handle or "stick" part.
    I will share how once I find the stick, its pretty easy actually.

    Thank you
     
  2. Insecticon

    Insecticon I am a Transformers

    Joined:
    Jan 21, 2009
    Posts:
    452
    Trophy Points:
    76
    Likes:
    +0
    Ebay:
    Lego makes these ~5mm diameter connector pieces for their Technic and Bionicle lines that can fit an average TF hand almost perfectly.

    These are the pieces that fit a 5mm slot almost perfectly. Might need a little adjusting, but no extensive mods. The only downfall is that these pieces are small, but not too difficult to work with. A radicon discovered that you can turn Minicons into Targetmasters with these :) 
    http://www.bricklink.com/catalogItem.asp?P=4459

    This piece is just barely smaller than what a TF can hold, but it is longer than the above piece and you can make it thicker via electrical tape or whatnot:
    http://www.bricklink.com/catalogItem.asp?P=3708

    Hope this helps, there may be something better out there, but these are what came to mind when I read your post.
     
    Last edited: Jul 9, 2011
  3. Cranckasional

    Cranckasional Well-Known Member

    Joined:
    Jun 6, 2011
    Posts:
    405
    News Credits:
    2
    Trophy Points:
    76
    Likes:
    +2
    Hey I have one of those laying around, good idea Thanks
     

Share This Page