Customs: Help needed: 3D printed parts

Discussion in 'Creative General Discussion' started by jbwkkl, Oct 20, 2018.

  1. jbwkkl

    jbwkkl Wrecker for life

    Joined:
    May 17, 2010
    Posts:
    2,083
    Trophy Points:
    222
    Likes:
    +1,577
    Anyone here able to print a pair of 5mm port adaptors for POTP Rampage? I've talked to SteamShield on Shapeways, he has a 4-piece set of ports available, but they don't have rounded bases (to help blend with Rampage's shoulders)

    Unfortunately, he has no plans to pickup POTP Predaking, so isn't able to mod his existing design to fit properly. Was hoping that someone here might be able to help. Since the G1 Predacon weapons fit the new figures just fine, was looking for a pair of rounded 5mm port adaptors to put on Rampage. He's the only member of Predaking that is currently not able to hold 2 guns in combiner mode. (can fit Divebomb, Headstrong, and Tantrum all with their respective G1 rifles in combined mode)
     
    • Like Like x 1
  2. jbwkkl

    jbwkkl Wrecker for life

    Joined:
    May 17, 2010
    Posts:
    2,083
    Trophy Points:
    222
    Likes:
    +1,577
    • Like Like x 1
  3. jbwkkl

    jbwkkl Wrecker for life

    Joined:
    May 17, 2010
    Posts:
    2,083
    Trophy Points:
    222
    Likes:
    +1,577
    If anyone is interested in the ports that @Treadshot A1 designed, Tamiya's "Gold Flake" acrylic (#X-12) is a near perfect color match to Rampage's copper highlights. Will just need a satin finish sealant to help it match (I used clear gloss sealant, and it made it a little too glossy by comparison)

    DSC05184.JPG
     
    • Like Like x 1

Share This Page