Customs: Head Swap Idea/Question

Discussion in 'Creative General Discussion' started by Ravenxl7, Jun 8, 2011.

  1. Ravenxl7

    Ravenxl7 W.A.F.F.L.E.O.

    Joined:
    Jun 7, 2006
    Posts:
    22,159
    News Credits:
    20
    Trophy Points:
    312
    Likes:
    +40
    Since I have no plans to connect any PCC limbs to my Huffer figure, I've been trying to figure out a use for his combined-mode head.

    Also, I've been considering buying the DotM Topspin figure (or wait for one of it's repaints), but I honestly can't stand his head-sculpt.

    I remember seeing a picture on 4chan of the Topspin figure that someone had replaced the head with that of the combined-mode head of the PCC helicopter guy.

    I'm not sure if the ball joint would be the same size, but would it at all be possible to do a similar head swap, but with Huffer's combined-mode head?
     
  2. Hooper_X

    Hooper_X hi haters

    Joined:
    Jun 10, 2003
    Posts:
    1,274
    Trophy Points:
    197
    Likes:
    +55
    The ball joint is not the same size - Huffer's is a lot bigger. You'd need to put superglue on Topspin's neck.
     
  3. Ravenxl7

    Ravenxl7 W.A.F.F.L.E.O.

    Joined:
    Jun 7, 2006
    Posts:
    22,159
    News Credits:
    20
    Trophy Points:
    312
    Likes:
    +40
    Hmmm...that's too bad. Though it shouldn't be too hard to either build-up the ball joint, or replace it entirely. Thanks for the help.
     
  4. deliciouspeter

    deliciouspeter Back in Black TFW2005 Supporter

    Joined:
    May 18, 2007
    Posts:
    4,353
    News Credits:
    2
    Trophy Points:
    217
    Likes:
    +61
    Ebay:
    You might be able to pull the ball and joint from the PCC and implant the whole thing into Topspin. I do that quite a bit.
     

Share This Page