Customs: G1 Hardware

Discussion in 'Creative General Discussion' started by haventgrownup, Nov 2, 2011.

  1. haventgrownup

    haventgrownup Procrastinator

    Joined:
    May 20, 2011
    Posts:
    1,556
    Trophy Points:
    157
    Likes:
    +80
    Hope to repair and replace some of the hardware on my vintage figures, and to "de-neuter" some launchers.

    Is there a source to buy screws, pins with textured ends (of varying lengths), small springs, brads with splitting heads, etc.?

    For the figures that have had the springs removed from launchers, is there a resource that has the length and lumen diameters for each launcher? If so, is there a nomenclature I can use to specific measurements?
     

Share This Page