Customs: G1 Galvatron Electronics

Discussion in 'Creative General Discussion' started by acollier, Feb 1, 2008.

  1. acollier

    acollier Well-Known Member

    Oct 26, 2004
    Trophy Points:
    Ok, tough one. I chopped up a G1 Galvatron reissue for my Energon Megatron repaint/mod.

    Now, are there any clever people out there who can figure out how to put the electronics into the Energon mold? I.m basically putting it into a repaint very similar to the Jin one but with a much shorter front cannon section, cut to be level with the shoulder mounts to be exact.

    I have all three modes, so the handle for the gun mode is also attached to Galvy's back. It would be nice to have the sounds.

    Has anyone actually DONE this?

    Any input(Stephanie)?


Share This Page