Customs: does any one know how to take demolishers bucket of

Discussion in 'Creative General Discussion' started by firebapx, Aug 29, 2010.

  1. firebapx

    firebapx Starscream

    Joined:
    May 12, 2010
    Posts:
    123
    Trophy Points:
    56
    Likes:
    +0
    hi im making my own version of demolisher and i need to remove his bucket to do him does any one know how to take the bucket of just the scoop at the end not the whole arm
     
  2. tf7

    tf7 Well-Known Member

    Joined:
    Nov 26, 2008
    Posts:
    779
    News Credits:
    1
    Trophy Points:
    101
    Likes:
    +1
    Uh, remove the pin with a pin remover? That's what I'd do. Though I'm not quite good with a pin remover though...
     
  3. firebapx

    firebapx Starscream

    Joined:
    May 12, 2010
    Posts:
    123
    Trophy Points:
    56
    Likes:
    +0
    the pins only exposed at one side
     
  4. John_Force

    John_Force 16xNHRA Funny Car Champ TFW2005 Supporter

    Joined:
    Jun 26, 2009
    Posts:
    2,376
    News Credits:
    1
    Trophy Points:
    196
    Likes:
    +1
    Going off the pictures in the Resources section, I would hazard a guess that the best thing to do is to pop out the pin on the outside, Transform it to robot mode and then attempt to remove the other pin from the inside. Given how the bucket splits apart for robot mode, there has to be 2 pins to allow for the separation.
     

Share This Page