Here is the beginning of my version of Defensor. I'm not sure what vehicles I am going to use to complete the combined form. I'm using the Mudflap mold in an unconventional way by sectioning part of it to become Hotspot. The back 2/3 will become the main body of Defensor, with Hotspot as a leg, and then 3 other vehicles to become the other three limbs. I am not planning on using a motorcycle for a limb due to the size difference of a motorcycle and full size vehicle. I might use a M cycle as a head, if I can get a decent looking head to form from a bike design and be a robot. On to the photos and descriptions: I found a use for the Classics G1 Optimus mold. I combined it with the cab of Mudflap to give me a seperate cab. I wish the vehicle didn't have the extra gap between the cab and trailer but it was neccesary to form Hotspot. Hotspot has a little bit of the Fatimus Prime problem that E Prime has. It would take better modifying skills, than I have, to change that with this combination. I didn't take a photo of it but Hotspot now has a spot to carry the Matrix, if it was passed to him, in the bumper. (get in my belly) Now for the combined mode your going to need a little imagination, since I could not get left foot and C Clocker to support the main body, properly. I might use Clocker for this part but I haven't done any modifications, yet, to that mold. The rear bumper, becomes the left foot, so you have somewhat matching toes just like the Mudflap mold has. (except it is still in the bumper form to match the front bumper of the right foot). I just need to find molds for an ambulance and rescue vehicle to become the arms. The head of Mudflap can still become the head of Defensor until I figure out about a motorcycle/robot/head. Hopefully everyone likes my idea but let me know what you think, either way. Later.