Customs: Best way to tighten Classics seeker mold

Discussion in 'Creative General Discussion' started by Wyvern, Feb 9, 2009.

  1. Wyvern

    Wyvern Velvet Sanchez

    Joined:
    Feb 7, 2003
    Posts:
    8,364
    News Credits:
    1
    Trophy Points:
    226
    Likes:
    +1
    Ok, so I know about using superglue and nail polish to tighten ball joints. I did that to my Henkei Skywarp. He's now good as new in those areas. But now I want to tighten up his very loose foot joint. How would I do this? Can I use superglue?? Its not a ball joint... its more of a hinge...a pin.
     
  2. frenzyrumble

    frenzyrumble Banned

    Joined:
    Jun 7, 2007
    Posts:
    8,657
    News Credits:
    50
    Trophy Points:
    176
    Likes:
    +50
    you can dab some super glue in there, but a minimal amount. then, keep the foot moving on it's hinge until the glue dries. It's imperative that you don't stop moving the part on the pin until it's completely dry. Allow some of the glue to drip into the pin's hole of the foot.
     
  3. TonyzCustomz

    TonyzCustomz Am I doin it rite? TFW2005 Supporter

    Joined:
    Aug 31, 2007
    Posts:
    2,747
    News Credits:
    2
    Trophy Points:
    181
    Likes:
    +2
    Ebay:
    Coat it in future floor polish
     

Share This Page