3D Artwork: 3D Blastoff WIP

Discussion in 'Transformers Fan Art' started by SilverBlade, Sep 2, 2007.

  1. SilverBlade

    SilverBlade Well-Known Member

    Joined:
    Apr 7, 2005
    Posts:
    221
    Trophy Points:
    91
    Likes:
    +0
    I'm working on a 3D version of Blastoff. So far I've done his arm. Comments/suggestions are appreciated.


    [​IMG]
     
  2. Star Cracker

    Star Cracker Well-Known Member

    Joined:
    Aug 27, 2003
    Posts:
    1,116
    Trophy Points:
    177
    Likes:
    +2
    A little early to tell, but so far, it looks good with the finger joints (doesn't look like they'll clip). I could advice some tips on the elbow joint in that it's going to use the same joint mechanism that you've got going for the fingers.

    Looks okay other than that. I'll need to take a good look at Blast Off again.
     
  3. SilverBlade

    SilverBlade Well-Known Member

    Joined:
    Apr 7, 2005
    Posts:
    221
    Trophy Points:
    91
    Likes:
    +0
    yeah, I made sure that no parts were clipping.
     
  4. SilverBlade

    SilverBlade Well-Known Member

    Joined:
    Apr 7, 2005
    Posts:
    221
    Trophy Points:
    91
    Likes:
    +0
    any other thoughts from the other 3D artists out there?
     
  5. BMGFX

    BMGFX Awesome Spooner Veteran

    Joined:
    Jun 24, 2002
    Posts:
    3,467
    Trophy Points:
    211
    Likes:
    +0
    Seems like a good start. I'd say keep going with it :) 
     
  6. Star Cracker

    Star Cracker Well-Known Member

    Joined:
    Aug 27, 2003
    Posts:
    1,116
    Trophy Points:
    177
    Likes:
    +2
    A way to get modeling feedback would be to post screenshots of a wireframe and multiple views to get a better sense of proportions and polygonal topology.
     

Share This Page