2.0 Galvatron question?

Discussion in 'Transformers Toy Discussion' started by Bluestreak76, Oct 11, 2008.

  1. Bluestreak76

    Bluestreak76 Well-Known Member

    Joined:
    Oct 10, 2008
    Posts:
    155
    Trophy Points:
    56
    Likes:
    +0
    I just got the new Galvatron. Needless to say he was fun to transform.

    I'm curious about tank mode. The connector for his turret sits at an angle on his body so the turret sits crooked. I looked at where the connector is supposed to lay and it looks flat but I cant seem to get the connector (orange peice) to sit flush....the hinge bends or goes wonky. Is it supposed to be like this or is it a manufacturing defect? If I play around with the turret I can get it to straighten out and it is a shelf model but I was just curious.
     
  2. BrokenSVT

    BrokenSVT It's not broken anymore.

    Joined:
    Feb 28, 2008
    Posts:
    1,323
    Trophy Points:
    126
    Likes:
    +0
    Sounds like you didn't slide the orange piece that carries the turret and the arm far enough to the top of the tank. It's tricky, try to reverse the transformeation a step or two and go from there.
     
  3. Bluestreak76

    Bluestreak76 Well-Known Member

    Joined:
    Oct 10, 2008
    Posts:
    155
    Trophy Points:
    56
    Likes:
    +0
    Oh its all the way at the top, its just when I fold it over, it still wont sit flat. Its almost like the arm is too long or something. I'm a tinkerer so I will figure it out lol.
     

Share This Page