Minor/Repaint: 2014 SDCC Dinobot Ark Drawer Retrofit

Discussion in 'Radicons Customs' started by firehawc_69, May 21, 2015.

  1. firehawc_69, May 21, 2015
    #1
    firehawc_69

    firehawc_69 cloppers = ignore list

    Joined:
    Aug 12, 2008
    Posts:
    10,633
    News Credits:
    9
    Trophy Points:
    267
    Likes:
    +34
    Not the most elegant, but I didn't see anyone else's. I wanted to add Sludge to the G1
    SDCC Ark drawer, and figured out a simple layout. I cut the foam where Slag was to accommodate Sludge, moved Slag under Grimlock and cut appropriately. I plugged Swoop's lances into his wings, and cut a slit where they were to accommodate his crossbow.

    Again, not the most elegant, but I thought I'd share anyway, as I figure others got this Sludge deco for this purpose too.:

    [​IMG]
     

    Attached Files:

  2. Superquad7, May 21, 2015
    #2
    Superquad7

    Superquad7 OCP Police Crime Prevention Unit 001 Super Content Contributor

    Joined:
    May 19, 2003
    Posts:
    52,491
    News Credits:
    16
    Trophy Points:
    447
    Likes:
    +7,414
    Twitter:
    Looks like you did a good job. What did you use to cut with?
     
  3. firehawc_69, May 21, 2015
    #3
    firehawc_69

    firehawc_69 cloppers = ignore list

    Joined:
    Aug 12, 2008
    Posts:
    10,633
    News Credits:
    9
    Trophy Points:
    267
    Likes:
    +34
    Thanks! I just used a sharp kitchen knife.